Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual page 50

Installing a Supervisor Engine or Route Switch Processor
Carefully slide the module into the slot until the EMI gasket on the module makes contact with the
Step 5
module in the adjacent slot and both ejector levers have closed to approximately 45 degrees with respect
to the module faceplate. (See
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a
Step 6
small (0.040 inch [1 mm]) gap between the module EMI gasket and the adjacent module.
(See Figure
Do not press down too forcefully on the ejector levers. They will bend and be damaged.
Caution
Figure 3-3
While pressing down, simultaneously close both ejector levers to fully seat the module in the backplane
Step 7
connector. The ejector levers are fully closed when they are flush with the module faceplate.
Note
Step 8 Tighten the two captive installation screws on the module.
Note
Blank module filler plates (Cisco part number 800-00292-01) should be installed in any empty chassis
Note
slots to keep dust out of the chassis and to maintain consistent airflow through the chassis.
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
3-6
Chapter 3
Figure 3-3.)
3-3.)
Clearing the EMI Gasket
Press down
WS-X6 K-SUP 2-2GE
CONSOL E
PORT
MODE
CONSOL E
SUPER VISOR 2
PCMCIA
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
4
5
6
Failure to fully seat the module in the backplane connector can result in error messages.
Make sure the ejector levers are fully closed before tightening the captive installation screws.
Installing and Configuring Route Switch Processors and Supervisor Engines
Press down
Switch
Load
100%
PORT 1
PORT 2
EJECT
1%
1mm Gap between the module
EMI gasket and the
module above it.
OL-10100-11