Removing And Installing The Sa-Vam2; Handling The Sa-Vam2 - Cisco SA-VAM - VPN Acceleration Module Installation And Configuration Manual

Removing and Installing the SA-VAM2+

This chapter describes how to remove the Service Adapter VPN Acceleration Module 2+ (SA-VAM2+)
from the supported platforms and how to install a new or replacement SA-VAM2+.
Before you begin installation, read
required for installation.
This chapter contains the following sections:
•
•
•
•
Note To ensure proper airflow in the router and compliance with EMI prevention standards, an empty port
adapter slot must have a blank port adapter (part number 800-00455-01) installed in it.
The SA-VAM2+ circuit board is sensitive to ESD damage.

Handling the SA-VAM2+

Always handle the SA-VAM2+ by the carrier edges and handle; never touch the SA-VAM2+
Caution
components. (See
Figure 3-1
OL-5979-03
Handling the SA-VAM2+, page 3-1
Online Insertion and Removal (OIR), page 3-2
Warnings and Cautions, page 3-2
SA-VAM2+ Removal and Installation, page 3-2
Figure 3-1.)
Handling the SA-VAM2+
Metal carrier
Printed circuit board
C H A P T E R
Chapter 2, "Preparing for Installation"
VPN Acceleration Module 2+ (VAM2+) Installation and Configuration Guide
3
for a list of parts and tools
3-1