Table of Contents
Advertisement
Supported Standards, MIBs, and RFCs
Table 1-2
Cisco Router
Cisco 7200VXR
with NPE-400
Cisco 7200VXR
with NPE-225
1. As measured with IPSec 3DES Hashed Message Authentication Code (HMAC)-SHA-1 on 1400-byte packets. Performance
2. Using Cisco 12.3-10 image. Performance varies by Cisco IOS release. It is recommended that you download the most recent
Supported Standards, MIBs, and RFCs
This section describes the standards, Management Information Bases (MIBs), and Request for
Comments (RFCs) supported on the SA-VAM2+. Requests for Comments (RFCs) contain information
about the supported Internet suite of protocols.
Standards
•
•
MIBs
•
•
•
To obtain lists of supported MIBs by platform and Cisco IOS release, and to download MIB modules,
go to the Cisco MIB website on Cisco.com at the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
RFCs
•
•
VPN Acceleration Module 2+ (VAM2+) Installation and Configuration Guide
1-6
Performance for SA-VAM2+ (continued)
Throughput
Up to 248 Mbps
Up to 251 Mbps
Up to 191 Mbps
varies depending on the number of modules, bandwidth, traffic volume, Cisco IOS release, etc.
image for your Cisco 7200VXR or Cisco 7301 router.
IPPCP: RFC 2393, 2395
IPSec/IKE: RFCs 2401-2411, 2451
CISCO-IPSEC-FLOW-MONITOR-MIB
CISCO-IPSEC-MIB
CISCO-IPSEC-POLICY-MAP-MIB
IPPCP: RFC 2393, 2395
IPSec/IKE: RFCs 2401-2411, 2451
1 2
Description
Cisco IOS release: c7200-jk9o3s-mz.124-4.T1
7200VXR/NPE400/SA-VAM2+, 512MB system memory
3DES/SHA, preshared with no IKE-keepalive configured
Cisco IOS release: c7200-jk9o3s-mz. 124-4.T1
17200VXR/NPE400/single SA-VAM2+, 512MB system
memory
AES/SHA, preshared with no IKE-keepalive configured
Cisco IOS release: c7200-jk9o3s-mz.123-10
7200VXR/NPE225/single VAM2+, 256MB system memory
3DES/SHA, preshared with no IKE-keepalive configured
Chapter 1
Overview
2
OL-5979-03
Advertisement
Table of Contents
