Cisco SA-VAM - VPN Acceleration Module Installation And Configuration Manual page 37

Chapter 3 Removing and Installing the SA-VAM2+
Figure 3-4
1 Unlocked position
Grasp the handle of the SA-VAM2+ and pull the SA-VAM2+ from the router. If you are removing a blank
Step 4
port adapter, pull it completely out of the chassis slot.
Carefully align the new SA-VAM2+ carrier between the upper and the lower edges of the port adapter
Step 5
slot. (See
To prevent jamming the carrier between the upper and the lower edges of the port adapter slot, and to
Caution
ensure that the edge connector at the rear of the SA-VAM2+ mates with the connection at the rear of the
port adapter slot, make certain that the carrier is positioned correctly, as shown in the cutaway in
Figure
Figure 3-5
1
1 Upper edge of the port adapter slot
OL-5979-03
Placing the Port Adapter Lever in the Unlocked/Locked Position - Cisco 7206VXR
Shown
Cisco 7200
Series
Figure 3-5.)
3-5.
Sliding the SA-VAM2+ into the Port Adapter Slot - Cisco 7206VXR Shown
Cisco 7200
Series
VPN Acceleration Module 2+ (VAM2+) Installation and Configuration Guide
SA-VAM2+ Removal and Installation
1
FAST ETHERNET INPUT/OUTPUT CONTROLLER
2
2 Locked position
FAST ETHERNET INPUT/OUTPUT CONTROLLER
3-5