Table of Contents
Advertisement
ServerGuide problems
Use this information to locate ServerGuide problems and suggested actions.
The following table lists problem symptoms and suggested solutions.
Symptom
The ServerGuide Setup and
Installation CD will not start.
The RAID configuration
program cannot view all
installed drives, or the
operating system cannot be
installed.
The operating-system
installation program
continuously loops.
The ServerGuide program will
not start the operating-system
CD.
The operating system cannot be
installed; the option is not
available.
Suggested action
v Make sure that the CD drive is associated with the blade server that you are
configuring.
v Make sure that the blade server supports the ServerGuide program and has a
bootable CD (or DVD) drive.
v If the startup (boot) sequence settings have been changed, make sure that the
CD drive is first in the startup sequence.
v Make sure that there are no duplicate SCSI/SAS IDs or interrupt request (IRQ)
assignments. See "Configuring a SAS RAID array" on page 42.
v Make sure that the storage drive is connected correctly. See "Blade server
connectors" on page 14 to locate the storage drive connector.
Make more space available on the hard disk.
Make sure that the operating-system CD is supported by the ServerGuide
program. See the ServerGuide Setup and Installation CD label for a list of supported
operating-system versions.
Make sure that the operating system is supported on the blade server. If the
operating system is supported, either no logical drive is defined (SCSI/SAS RAID
systems) or the ServerGuide System Partition is not present. Run the ServerGuide
program and make sure that setup is complete.
Chapter 6. Solving problems
49
Advertisement
Table of Contents
