Table of Contents
Advertisement
Release handles
(open)
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If you have not done so already, install any optional devices that you want,
3. Select the I/O-module bay for the blade server; at least one I/O-module bay is
4. Make sure that the release handles on the blade server are in the open position
5. Slide the blade server into the I/O-module bay until it stops.
6. Push the release handles on the front of the blade server to the closed position.
7. Turn on the blade server (see "Turning on the blade server" on page 13 for
8. Make sure that the power-on LED on the blade server control panel is lit
9. If you have other blade servers to install, do so now.
32
BladeCenter HS12 Type 8014 or 8028: Installation and User's Guide
page 15.
such as hard disk drives, memory, or an InfiniBand high-speed expansion card,
in the blade server.
required.
Notes:
a. When any blade server or device is in any I/O-module bay 7 through 14,
power modules must be installed in all four power-module bays. For
additional information, see the Installation and User's Guide that comes with
the BladeCenter unit.
b. To help ensure proper cooling, performance, and system reliability, make
sure that each I/O-module bay on the front of the BladeCenter unit contains
a blade server, expansion unit, or blade filler. Do not operate a BladeCenter
unit for more than 1 minute without a blade server, expansion unit, or
blade filler in each I/O-module bay.
(perpendicular to the blade server).
instructions).
continuously, indicating that the blade server is receiving power and is turned
on.
Advertisement
Table of Contents
