Services Modules
LEDs on the 14/2-Port Multiprotocol Services Module
Table 1-7
Table 1-7
LED
Status Green
Speed On
Link
IP Storage Services Modules
The 8-port and 4-port IP Storage services (IPS-8 and IPS-4) modules provide eight or four 1-Gigabit
Ethernet ports for iSCSI as well as FCIP over Gigabit Ethernet, and they support the intelligent features
available on other modules, including VSANs, security, and traffic management.
The IPS module ports support the iSCSI protocol, the FCIP protocol, or both protocols simultaneously.
For information about configuring the ports, see the Cisco MDS 9000 Family CLI Configuration Guide
and the Cisco MDS 9000 Family Fabric Manager Configuration Guide.
Cisco MDS 9200 Series Hardware Installation Guide
1-24
describes the LEDs for the MPS-14/2 modules.
LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules
Status
Description
All diagnostics pass. The module is operational (normal
initialization sequence).
Orange
One of the following occurs or occurred:
The module is booting or running diagnostics (normal
•
initialization sequence).
•
The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red
One of the following occurred:
The diagnostic test failed. The module is not operational
•
because a fault occurred during the initialization
sequence.
•
he inlet air temperature of the system exceeded the safe
T
operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
2-Gbps mode.
Off
1-Gbps mode.
Flashing
Link is up (beacon used to identify port).
green
Solid
Link is up.
green
Solid
Link is disabled by software.
yellow
Flashing
A fault condition exists.
yellow
Off
No link.
Chapter 1
Product Overview
OL-16188-01