Environmental And Power Requirements Specifications For Cisco 10-Gbps Ethernet X2 Transceiver; Sfp Transceiver Specifications - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Appendix B Technical Specifications

Environmental and Power Requirements Specifications for Cisco 10-Gbps Ethernet X2 Transceiver

Table B-14
transceiver.
Table B-14
X2
DS-X2-E10G-SR -1.2
Table B-15
Table B-15
X2
DS-X2-E10G-SR
For information about safety, regulatory, and standards compliance, refer to the Regulatory Compliance
and Safety Information for the Cisco MDS 9000 Family.

SFP Transceiver Specifications

The Cisco MDS 9200 Series is compatible with SFP transceivers and cables that have LC connectors.
Each transceiver must match the transceiver on the other end of the cable in terms of wavelength, and
the cable must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers provide the uplink interfaces, laser transmit (TX) and laser receive (RX), and
support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9200 Series. Each Cisco SFP transceiver is encoded
with model information that enables the switch to verify that the SFP transceiver meets the requirements
for the switch.
Generation 2 modules will not support 1-Gbps/2-Gbps SFPs. Generation 2 modules only support 4-Gbps
Note
SFPs.
This section provides the following topics:
•
•
•
•
•
OL-16188-01
provides the power requirement specifications for the Cisco 10-Gbps Ethernet X2
Power Requirement Specification for Cisco 10-Gbps Ethernet X2 Transceivers
Average Transmit
Power (dBm)
Maximum
provides the environmental specifications for the Cisco 10-Gbps Ethernet X2 transceivers.
Environmental Specifications for Cisco 10-Gbps Ethernet X2 Transceiver
Operating
Maximum
40°C
Cisco Fibre Channel SFP Transceivers, page B-10
Cisco Fibre Channel/Gigabit Ethernet Transceivers, page B-13
Cisco CWDM SFP Transceivers, page B-15
Cisco Gigabit Ethernet Transceivers, page B-19
DWDM Fibre Channel SFP Transceivers, page B-20
Average Receive
Power (dBm)
Minimum Maximum
-7.3 -1.0
Storage
Minimum Maximum
0°C 85°C
Cisco MDS 9200 Series Hardware Installation Guide
SFP Transceiver Specifications
Fiber Loss
Budget (dBm)
Minimum
-9.9 2.6 (50.0
micron-OM3)
Minimum
-40°C
B-9