Installing The Shelf Bracket Kit Into A Four-Post Eia Rack - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Appendix A Cabinet and Rack Installation

Installing the Shelf Bracket Kit into a Four-Post EIA Rack

Figure A-2
Figure A-2
1
1 Rack-mounting rail (4x)
2 Shelf bracket (2x)
3 Slider rail (2)
To install the shelf brackets in an EIA rack, follow these steps:
Position a shelf bracket inside the rack-mounting rails as shown in
Step 1
the front of the shelf bracket with the holes in the front rack-mounting rail. Then, attach the shelf bracket
to the front rack-mounting rail using a minimum of four 12-24 or 10-24 screws.
Note
Repeat with the other shelf bracket.
Step 2
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 3
OL-16188-01
shows the installation of the shelf bracket kit into a four-post EIA rack.
Installing the Shelf Bracket Kit into an EIA Rack
2
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-in. spacing).
Cisco MDS 9000 Family telco and EIA Shelf Bracket
3
4
5
4 Crossbar
5 10-32 screws (2x)
Cisco MDS 9200 Series Hardware Installation Guide
Figure A-2. Align the screw holes at
A-7