Chapter 1
Product Overview
LEDs on the Interface Module
Table 1-2
Table 1-2
LED
Status
System
MGMT 10/100
Ethernet Link
LED
MGMT 10/100
Ethernet
Activity LED
OL-16188-01
describes the LEDs for the Cisco MDS 9200 Series interface module.
LEDs on the Cisco MDS 9200 Series Interface Module
Status
Description
Green
All diagnostics pass. The module is operational
(normal initialization sequence).
Orange One of the following occurs or occurred:
The module is booting or running diagnostics
•
(normal initialization sequence).
The inlet air temperature of the system exceeded
•
the maximum system operating temperature limit
(a minor environmental warning). To ensure
maximum product life, you should immediately
correct the environmental temperature and
restore the system to normal operation.
Red
One of the following occurred:
The diagnostic test failed. The module is not
•
operational because a fault occurred during the
initialization sequence.
he inlet air temperature of the system exceeded
•
T
the safe operating temperature limits of the card
(a major environmental warning). The card shut
down to prevent permanent damage.
Green
All chassis environmental monitors are reporting OK.
Orange One of the following occurs or occurred:
•
The power supply failed or the power supply fan
failed.
Incompatible power supplies are installed.
•
The redundant clock failed.
•
Red
The temperature of the supervisor module exceeded
the major threshold.
Green
Link is up.
Off
No link.
Green
Traffic is flowing through port.
Off
No link or no traffic.
Cisco MDS 9200 Series Hardware Installation Guide
Interface Modules
1-11