Uplink Fast General Configuration
To display the following form, select Layer 2 > UpLink Fast.
The following table describes the Uplink Fast Configuration controls:
Uplink Fast Configuration controls
Table 126
Control
Enabled?
Update Rate (10-200)
Description
Enables or disables Fast Uplink Convergence, which provides rapid Spanning Tree
convergence to an upstream switch during failover.
NOTE:
When enabled, this feature increases bridge priorities to 65500 for all
STGs and path cost by 3000 for all external STP ports.
Configures the station update rate. The default value is 40.
Configuring the switch
185