Shutting Down and Restarting
Startup Steps
Note
Use this chapter when you are starting up, or shutting down, or
restarting the server after the first time you started it. When you
start the server for the first time, refer instead to one of the
following:
•
Quick Setup sheet
•
"Connecting and Starting Up" on page 2-8
Starting Up the Server
1. Attach the two power cords to the rear of the server and to
power outlets (preferably to separate power circuits).
2. On the front of the server, switch on power. (See the front view
illustrated on page 6-2.)
3. Verify that:
•
The main power light (LED) above the power switch is on
and the power display (2-character LED) displays
•
Drive power and drive activity lights (LEDs) blink to
indicate self-tests. The drive power light on each disk drive
module remains green.
•
The control panel (LCD) displays self-testing and loading
messages.
If you see any of the following exceptions to the verification
checks listed above, refer to chapter 11, "Resolving Problems
with Your Server".
•
Lights described above fail to go on.
•
Power display shows
•
Control panel displays
•
Control panel remains unchanged for more than 10 seconds.
or
or
.
or
anywhere in the text.
Shutting Down and Restarting 6
6
.
-
1