Supplying The Password For Access - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Supplying the
Password for
Access
If you do press
completed, you will be prompted for the control panel
password—if you have set one. In that case, see "Supplying the
Password for Access" on page 3-3, and then return here.
The control panel display then alternates the following
instructions for setup mode:
Ç
Press any control panel button or wait (about 30 seconds) to
proceed with setup mode.
The settings are listed in the table on page 3-6. For procedures that
use the control panel, refer to the following:
•
For shutdown see chapter 6, "Shutting Down and Restarting".
•
To check errors and alerts see chapter 11, "Resolving Problems
with Your Server".
You will be prompted as shown below for the control panel
password—if you have set one. (See
page 3-6.)
The first character position on the second line of the display is
flashing. To specify each character you may:
•
Press (up button) on the control panel to cycle through each
letter of the alphabet and each digit.
•
Press (down button) on the control panel to cycle through
each letter and digit in the opposite sequence.
•
Accept the character by pressing
flashes. Specify that character in the same way.
You may go back (left) by pressing
needed character is flashing. Then press
When the password is complete, press
position.
before the countdown of 10 seconds is
È
for each character until the
Configuration Using the Control Panel 3
in the table on
. The next character position
or to change it.
at a blank character
-
3