Control Panel Setup - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Control Panel
Setup
Assign IP Address
Automatically
Assign IP Manually
5. You will be prompted on the control panel for the IP configuration
method as follows. (The two displays alternate.)
Startup cannot continue until an IP address is set. Press one of
the following keys on the control panel to select the method of
assigning IP addresses on your network:
• Press if the server IP address will be assigned on your
network using either DHCP (Dynamic Host Configuration
Protocol) or BOOTP (Bootstrap Protocol). See
"DHCP/BOOTP server" on page 2-6 for more information.
Startup of the server will continue until the server is active
on the network. Skip to step 11 on page 2-12 to verify
normal operation.
• Press if you will assign the server an IP address manually
at the control panel. This will place you in the control
panel's setup mode.
6. Set the IP address manually at the next prompt:
The first character position on the second line of the display is
flashing. You may edit the digits one by one from left to right.
When a digit is flashing, you may:
• Increment each digit's value (change it "up")
by pressing
• Decrement each digit's value (change it "down")
by pressing
• Accept the digit by pressing
unless it was the last digit.
• You may go back (left) by pressing
needed digit is flashing. Then press
Note that if you press
you will cancel the setting of the entire parameter.
When the last of the 12 digits is flashing, pressing
accepts the address setting displayed. The scroll symbol 
returns to the first line of the display.
.
.
. This moves to the next digit,
when the first digit is flashing,
for each digit until the
or to change it.
again
Installation 2
-
9