System Fan - HP dx7400 - Microtower PC Service & Reference Manual
Service reference guide - hp compaq dx7400 business pc
Hide thumbs
Also See for dx7400 - Microtower PC:
- Troubleshooting manual (69 pages) ,
- Hardware reference manual (32 pages) ,
- Utility manual (19 pages)
Table of Contents
Advertisement
System Fan
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the cable that connects the system fan to the system board.
4.
Remove the two screws that secure the fan to the chassis (1), and then remove the fan from the
chassis (2).
5.
Cut the tie-wrap (1) at the bottom of the fan that secures the CPU power cable (2) to the fan.
To install the fan, reverse the removal procedures.
NOTE:
When installing the fan, the CPU power cable must be plugged into the system board before
securing the cable to the bottom of the fan cage. This will ensure that the cable is properly positioned.
(Preparation for Disassembly on page
(Access Panel on page
57).
56).
System Fan
77
Advertisement
Table of Contents
