Power Switch Assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the braided cables from the system board.
5.
Free the braided cables from the cable tie that is attached to the chassis.
6.
Press down on the top of the switch holder (1), rotate the switch downward (2), and then pull it
away from the chassis while guiding the wires through the hole in the chassis.
To install the power switch assembly, reverse the removal procedures.
74
Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
(Preparation for Disassembly on page
(Access Panel on page
(Front Bezel on page
58).
57).
56).