Removal and Replacement Procedures - Convertible Minitower (CMT) Chassis
✎
The computer automatically recognizes the additional memory when the computer is turned on.
To reassemble the computer, reverse the removal procedure.
✎
If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable
the Smart Cover Sensor.
6.10 Expansion Cards
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Locate the correct vacant expansion socket on the system board and the corresponding
expansion slot on the back of the computer chassis.
4. Push down and out on the two green thumb tabs inside the chassis and rotate the expansion
card retention latch up.
6–12
(Section
6.1).
(Section
6.5).
433612-001
Service Reference Guide, dc7700