Compaq dc7700 - Convertible Minitower PC Service & Reference Manual page 21

Heading Option
Security Smart Cover
(continued) (some models)
Embedded
Security (This menu
only appears after
the Embedded
Security Device is
made available
under Device
Security)
Device Security
Network Service
Boot
System IDs
DriveLock Security
✎
Support for specific Computer Setup options may vary depending on the hardware configuration.
Service Reference Guide, dc7700
Allows you to:
• Lock/unlock the Cover Lock.
• Set the Cover Removal Sensor to Disable/Notify User/Setup
Password.
✎
Notify User alerts the user that the sensor has detected that the
cover has been removed. Setup Password requires that the setup
password be entered to boot the computer if the sensor detects
that the cover has been removed.
Allows you to:
• Enable/disable the Embedded Security device.
• Reset the device to Factory Settings.
• Enable/disable power-on authentication support (some
models).
• Reset authentication credentials (some models).
This feature is supported on some models only.
Enables/disables serial ports, parallel port, all USB ports, system
audio, network controllers (some models), SMBus controller (some
models), and embedded security device (some models).
Enables/disables the computer's ability to boot from an operating
system installed on a network server. (Feature available on NIC
models only; the network controller must reside on the PCI bus or be
embedded on the system board.)
Allows you to set:
• Asset tag (18-byte identifier) and ownership Tag (80-byte
identifier displayed during POST).
• Chassis serial number or Universal Unique Identifier (UUID)
number. The UUID can only be updated if the current chassis
serial number is invalid. (These ID numbers are normally set in
the factory and are used to uniquely identify the system.)
• Keyboard locale setting (for example, English or German) for
System ID entry.
Allows you to assign or modify a master or user password for hard
drives. When this feature is enabled, the user is prompted to
provide one of the DriveLock passwords during POST. If neither is
successfully entered, the hard drive will remain inaccessible until
one of the passwords is successfully provided during a subsequent
cold-boot sequence.
✎
This selection will only appear when at least one drive that
supports the DriveLock feature is attached to the system.
433612-001
Setup Utilities and Diagnostics Features
Description
2–9