IMPORTANT SAFETY INSTRUCTIONS
WARNING:
To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions,
including the following:
Read all instructions
before using the dryer.
Do not place items exposed to cooking
oils in your dryer.
Items contaminated
with cooking oils may contribute
to
a chemical
reaction that could cause a load to catch fire.
•
Do not dry articles that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline, dry-
cleaning solvents, or other flammable or explosive
substances
as they give off vapors that could ignite or
explode.
•
Do not allow children to play on or in the dryer. Close
supervision
of children is necessary when the dryer is
used near children.
•
Before the dryer is removed from service or discarded,
remove the door to the drying compartment.
•
Do not reach into the dryer if the drum is moving.
•
Do not install or store the dryer where it will be exposed
to the weather.
•
Do not tamper with controls.
•
Do not repair or replace any part of the dryer or attempt
any servicing unless specifically recommended
in this
Use and Care Guide or in published user-repair
instructions that you understand and have the skills to
carry out.
•
Do not use fabric softeners or products to eliminate static
unless recommended
by the manufacturer
of the fabric
softener or product.
•
Do not use heat to dry articles containing foam rubber or
similarly textured rubber-like
materials.
•
Clean lint screen before or after each load.
•
Keep area around the exhaust opening and adjacent
surrounding
areas free from the accumulation
of lint, dust,
and dirt.
•
The interior of the dryer and exhaust vent should be
cleaned periodically by qualified service personnel.
•
See installation instructions
for grounding requirements.
SAVE THESE INSTRUCTIONS
Gather
the required
tools and parts before starting
installation.
Read and follow
the
instructions
provided
with
any tools listed here.
•
Flat-blade
screwdriver
•
Tin snips (new vent installations)
•
#2 Phillips
screwdriver
•
I.evel
Adjustable
wrench
that opens to 1"
(25 mm) or hex-head
socket wrench
(for adjusting
dryer feet)
•
Wire
stripper
(direct
wire installations)
•
Vent clamps
•
Caulking
gun and compound
(for installing
new exhaust
vent)
•
Tape measure
Parts supplied:
Remove parts package from dryer drum. Check that all parts were included.
B
D
E
A. Levering legs (4)
B. "Y" connector
C. Short
inlet hose
D. Inlet hose with
right-angle
connector
E. Rubber
washer
4