Maytag MEDB800VQ - R BravosR Steam Electric Dryer Use And Care Manual page 14

3.
4.
5.
Connect the other wires to outer terminal block screws. Tighten screws.
! !!
6°
3-wire connection: Direct Wire
Tighten strain relief screws.
Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
You have completed your electrical connection. Now go to "Venting Requirements."
Use where local codes permit connecting cabinet-ground conductor to neutral wire.
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed.
Strip 31/2'' (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If
using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape ends of
wires into a hook shape.
When connecting to the terminal block, place the hooked end of the wire under the screw of
the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
1. I.oosen or remove center silver-colored terminal block screw.
2.
3.
Place the hooked end of the neutral wire (white or center wire) of direct wire cable under
the center screw of terminal block (hook facing right). Squeeze hooked end together.
Tighten screw.
-m
...........
............... 2 ...........
A. External ground conductor screw
B. Neutral ground wire
C. Center silver-colored terminal block screw
D. Neutral wire (white or center wire)
E. 3/4" ( 19 ram) UL listed strain relief
Place the hooked ends of the other direct wire cable wires under the outer terminal block
screws (hooks facing right). Squeeze hooked ends together. Tighten screws.
!! !!
4. Tighten strain relief screw.
5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-
down screw.
6. You have completed your electrical connection. Now go to "Venting Requirements."
14