Cleaning Inside Of The Printer - Epson Stylus Pro WT7900 User Manual

Epson Stylus Pro WT7900/7910

Cleaning inside of the printer

If the print gets a scratch or smudge, follow the steps
below to wipe off the smudge inside of the printer.
Cleaning the roller
If the print is soiled by ink on the roller, follow the
steps below to clean the roller by feeding the
supported media.
A
Turn on the printer, and load the roll paper of
24-inch width.
See "Using Roll Paper" on page 32
B
Press the button to feed the paper.
Repeat step 2 for a few times until the paper is not
soiled with ink.
Cut the paper after cleaning is done.
See "Cutting the Roll Paper" on page 36
Cleaning inside
A
Make sure the printer is turned off and all the
lights are off, and then unplug the power cord
from the electrical outlet.
B
Leave the printer for a minute.
User's Guide
Maintenance
83
C
Open the front cover and use a soft, clean cloth
to carefully clean away any dust or dirt inside
the printer.
Wipe the gray part by following the directions
of the arrows. If there is a serious problem of
dirt on the inside of the printer, clean it using a
soft, clean cloth dampened with a mild
detergent. Then, wipe the inside of the printer
with a dry, soft cloth.
Caution:
c
❏ Do not touch the roller shown in the
illustration above, otherwise, prints
may be soiled.
❏ Do not touch the ink tubes located
inside the printer.
D
If the back of a print is soiled, wipe the gray
part carefully.