Roll X Is Empty. (X Is 1 (Upper) Or 2 (Lower); Lift The Release Lever And Replace The Roll; Press Ok - Canon imagePROGRAF iPF820 User Manual

Roll x is empty. (x is 1 (Upper) or 2 (Lower))

Lift the release lever and replace the roll.

The roll is empty.
There is remaining roll paper, but because it could
not be advanced, it could not be detected.

Press OK.

The roll is empty.
Cause
Cause
Corrective Action
Follow these steps to replace the used roll with a new
roll of the same type and size.
1.
Lift the Release Lever and remove the roll.
(→P.125)
(→P.129)
2.
Load the new roll.
(→P.115)
(→P.118)
3.
If no barcode was printed on the roll, specify the
type of paper.
(→P.113)
4.
If no barcode was printed on the roll, specify the
paper length.
(→P.114)
5.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Choose a higher level of Print Quality in the
Advanced Settings of the printer driver and try
printing again.
(→P.211)
Corrective Action
Follow these steps to replace the used roll with a new
roll of the same type and size.
1.
Press the OK button and remove the roll.
(→P.125)
(→P.129)
2.
Load the new roll.
(→P.115)
(→P.118)
3.
If no barcode was printed on the roll, specify the
type of paper.
(→P.113)
4.
If no barcode was printed on the roll, specify the
paper length.
(→P.114)
5.
If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Messages regarding paper
Error Message 655