Labeling An Input Source; Restoring Default Settings; Troubleshooting - Dynex DX-L321-10A User Manual

DX-L321-10A_09-0407_MAN_ENG_V3.book Page 22 Wednesday, May 13, 2009 11:38 AM
22
4 Press or to select the input source you want to assign a label
to, then press ENTER. The Custom Input Label screen for that
input source opens.
5 Press , , , or to select a label for the input source, then
press ENTER to apply the new label.
6 Repeated Steps 3–5 to apply labels to other input sources. These
labels are displayed when you press INPUT or any of the
individual input source keys.

Restoring default settings

Caution: When you restore default settings, all the settings (except the
password and parental rating) you have customized are reset.
To restore default settings:
1 Press MENU on the remote control, or MENU on the control
panel of your TV. The on-screen menu bar opens.
2 Press or to highlight Settings, then press ENTER. The
Settings menu opens.
3 Press or to highlight Reset All, then press ENTER. You are
asked for your PIN.
4 Enter your PIN number. A confirmation box opens.
Note: If you have forgotten your PIN, the default number is 9999.
5 Press or to select Yes, then press ENTER to load the default
menu settings.
After the system reset the Welcome prompt appears. Perform a
channel scan to reload the channels to your TV and then access
the on-screen menus to reconfigure the TV settings.

Troubleshooting

Warning: Do not try to repair your TV yourself. Contact authorized service
personnel.
Problem Solution
No power • Make sure that the power indicator is
illuminated blue.
• Make sure that the power cord is securely
connected to the AC-in jack and is plugged
into a functional AC outlet. You may want to
plug in another electrical device to the
power outlet to verify that it is supplying
the proper voltage.
Power is suddenly Press MENU and select Settings, Sleep Timer
turned off to make sure the Leave TV Off option is
selected.
Your PIN is 1. Press MENU and select Settings, Reset All,
compromised and then Yes.
2. Access the on-screen menu again and select
Locks.
3. Key in and reconfirm your new PIN.
Remote control • Replace the batteries. For more
does not work information, see "Installing remote control
batteries" on page 6.
• Make sure that the batteries are inserted
correctly. For more information, see
"Installing remote control batteries" on
page 6.
• Make sure that the power cord is plugged
into an AC power outlet.
The remote control • Purchase a separate learning remote
code cannot be control.
detected by a • Go to www.dynexproducts.com for a list of
universal remote remote control codes.
Troubleshooting