Connecting An External Audio Device; Turning On Your Tv For The First Time - Dynex DX-L321-10A User Manual

DX-L321-10A_09-0407_MAN_ENG_V3.book Page 11 Wednesday, May 13, 2009 11:38 AM

Turning on your TV for the first time

Connecting an external audio device

To connect an external audio device:
1 Make sure that your TV's power cord is unplugged and the
component video device is turned off.
2 Connect a digital optical (Toslink) cable to the SPDIF IN jack on
the digital audio device.
- or -
Connect audio cables (L and R) to the AUDIO IN jacks on the
analog audio device.
Stereo
Analog audio cables
Back of TV
3 Connect the other end of the digital optical (Toslink) cable to the
SPDIF OUT jack on the back of your TV.
- OR -
Connect the other end of the audio cables (L and R) to the AUDIO
OUT jacks on the back of your TV.
To play audio from an external audio device:
1 Turn on your TV.
2 Turn on the external audio device and set it to the correct output
mode. See the audio device's user guide for more information.
Turning on your TV for the first
time
Digital optical (Toslink)
audio cable
To configure your TV:
1 Make sure that you have inserted the batteries in the remote
control, connected the antenna to the TV, and connect the AC
power.
2 Press (Power), then wait several seconds. The setup wizard
opens (only the first time you turn on your TV) and guides you
through setting up your TV's operational settings.
3 Follow the on-screen prompts to finish setting up your TV.
Note:
• Channel auto scan is not necessary if you are using a satellite or cable
box.
• If you are using an antenna for a standard or HD TV signal, select Air.
• If your signal cable is directly connected to the TV (the tuner box is not
used), select Cable.
11