Inserting The Tape Cassette - Dymo Rhino 5200 Hard case Kit by User Manual

3. Close the battery compartment door.
4. To charge the battery pack, connect the AC
adapter as described below.
Connecting the AC Adapter
An optional AC power adapter can also be used to
power the printer. Connecting the AC adapter to
the printer disconnects the batteries as a power
source.
To connect the AC adapter
1. Plug the power adapter into the power connector
on the top, left side of the printer.
Figure 3
2. Plug the other end of the power adapter into a
power outlet.

Inserting the Tape Cassette

Your printer comes with one label tape cassette.
Visit www.dymo.com for information about
purchasing additional label cassettes.
To insert the tape cassette
1. Press the thumb catch on the right side of the
printer to open the tape cassette door.
2. Set the cassette switch for the size of the tape
cassette that you are inserting. See Figure 4.
A notch in the cassette fits over the switch when
the cassette is in the correct position.
The first time you use the printer, remove
the protective cardboard insert from between
the print head and pinch roller. See Figure 4.
4
4
Manual_RhinoPRO5000_WEU.indd 4
Remove
cardboard
insert
= 6 mm
= 9/12 mm
= 19 mm
Figure 4
3. Make sure the tape and ribbon are taut across
the mouth of the cassette and that the tape
passes between the guideposts. If necessary,
turn the spool clockwise to tighten the ribbon.
4. Insert the cassette with the tape and ribbon
positioned between the print head and pinch
roller. See Figure 5.
Push down gently
Print Head
Pinch Roller
Figure 5
5. Press firmly until cassette clicks into place. Make
sure tape and ribbon are positioned correctly.
6. Close the tape cassette door and press
turn on the power.
Tighten tape
Set cassette switch
A
to
23-07-2004 10:51:16