Event Record Mode - Samsung SHR-5082-250 User Manual

EVENT RECORD MODE

The detailed list for event mode settings is as
follows:
MENU SETUP
System
Camera
Monitoring
Record Mode
Event Record Alarm Detection Setup
Motion Detection Setup
Schedule
Video Loss Detection Setup
Backup
Network
Move/Control Select
Alarm Detection Setup
Alarm Detection Setup
Sensor State Cam
1 Off 1
2 Off 2
3 Off 3
4 Off 4
5 Off 5
6 Off 6
7 Off 7
8 Off 8
9-16
 Sensor State
- Off: Sensor does not operate.
- N.O (Normal Open): Sensor remains open
all the time. But if it gets closed, an alarm is
issued. (A Contact)
- N.C (Normal Close): Sensor remains closed
all the time. But if it gets open, an alarm is
issued. (B Contact)
 Cam
It is used to set a camera that synchronizes
with the current sensor. The default setting
follows the sensor number. A sensor can
synchronize with multiple cameras so multiple
values can be selected.
You can set a preset for each camera to
synchronize sensors with cameras. If a sensor
triggers the corresponding camera, the camera
can show you the preset location.
 Alarm-Out
It is used to set the Alarm-Out location when
any alarm occurs. Currently 5 Alarm Outs are
available. Select an alarm-out to synchronize
with the current sensor. But multiple values can
be selected.
 Duration
It is used to set the Alarm-Out duration. When
an alarm occurs, the alarm is output for the
preset time. You can select any of Off, 3sec,
5sec, 10sec, 20sec, 30sec, and Continuous.
In case of SHR-5082/5080, only 8
channels are displayed.
Exit
MENU
Alarm-Out Duration
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
OK Cancel
Motion Detection Setup
You can configure the motion detection related
settings. When the detection area is set, the
system detects any motion in that area.
Motion Detection Setup
Cam M.D State Area Sensitivity
1 Off Set Very High
2 Off Set Very High
3 Off Set Very High
4 Off Set Very High
5 Off Set Very High
6 Off Set Very High
7 Off Set Very High
8 Off Set Very High
9-16
 M.D State
- Off: Motion detection does not operate.
- On: Motion detection is active.
 Area
This is used to set the motion detection
area. It is not allowed to set 4 extreme rows
(Up, Down, Left, Right) because the display
boundary regions can vary according to the
monitor specification.
- Select All: Selects the whole area.
- Select One: Selects a block unit for each
time.
- Select Quarter: Selects a quarter unit of the
screen for each time.
- Clear All: Clears the whole selection.
- Save & Exit: Saves the setting and exits.
- Exit: Exits without saving.
Select All
Select One
Select Quarter
Clear All
Save & Exit
Exit
Alarm-Out Duration
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
None 10sec
OK Cancel
menu setup _31