Major Components Of The Server - IBM System x3400 Type 7975 Installation Manual

Major components of the server

Note: The major components of the server vary, depending on the machine type
Blue on a component indicates touch points, where you can grip the component to
remove it from or install it in the server, open or close a latch, and so on.
Orange on a component or an orange label on or near a component indicates that
the component can be hot-swapped, which means that if the server and operating
system support hot-swap capability, you can remove or install the component while
the server is running. (Orange can also indicate touch points on hot-swap
components.) See the instructions for removing or installing a specific hot-swap
component for any additional procedures that you might have to perform before you
remove or install the component.
The following illustration shows the major components in the server.
Note: The illustrations in this document might differ slightly from your hardware.
Rear adapter retention bracket
Heat sink
retention bracket
Microprocessor
Heatsink
Heat sink
filler
8
System x3400 Types 7973, 7974, 7975, and 7976: Installation Guide
and model.
Hot-swap power supply filler
Power supply cage
DIMM air duct
DIMMs
System board
ServeRAID 8k-1
VRM
Cover
Hot-swap power supply
Fixed power supply
Control panel assembly
SAS/SATA
backplane
SATA
Fan
backplate
assembly
Hot-swap fan
Hard disk drive
Processor baffle
EMC shield
Drive bay EMC shield
USB cable assembly
DVD
drive
Hot-swap
drive
DVD drive
trim piece
Hot-swap
Simple-swap
drive trim piece
drive
Bezel
Simple-swap
drive trim piece