IBM System x3400 Type 7975 Installation Manual page 40

2. Turn off the server and peripheral devices and disconnect all external cables
3. Unlock the side cover (you cannot open or remove the bezel without unlocking
4. Remove the bezel (see "Removing the bezel" on page 13.
5. Touch the static-protective package that contains the drive to any unpainted
6. Align the drive assembly with the guide rails in the bay (the connector end of
7. Press the drive assembly loops toward each other; then, carefully slide the drive
If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation" on page 31.
The simple-swap-drive backplate controls the IDs for the internal simple-swap drive
bays. The following table lists the IDs for the hard disk drives and backplate that
are connected to simple-swap models.
26
System x3400 Types 7973, 7974, 7975, and 7976: Installation Guide
and power cords.
the side cover).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
the drive goes in first).
assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
Device
Drive bay 4
Drive bay 5
Drive bay 6
Drive bay 7
ID
3
2
1
0