Battery - IBM LS20 - BladeCenter - 8850 Service Manual

Battery

The following notes describe information that you must consider when replacing the
battery in the server.
v When replacing the battery, you must replace it with a lithium battery of the same
v To order replacement batteries, call 1-800-426-7378 within the United States, and
v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To remove the battery, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the blade server and remove it from the BladeCenter unit (see
3. Open the blade server cover (see "Operating the blade server cover" on page
4. Locate the battery on the system board.
76
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM marketing representative or authorized reseller.
system date and time.
on page 59
"Removing and installing the blade server in a BladeCenter unit" on page 61 for
instructions).
64 for instructions).