I/O Expansion Card - IBM LS20 - BladeCenter - 8850 Service Manual

I/O expansion card

The following sections describe how to remove and replace small-form-factor and
standard-form-factor I/O expansion cards in the blade server.
Small-form-factor expansion card
To remove a small-form-factor expansion card, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Shut down the operating system, turn off the blade server, and remove the
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Open the cover (see "Operating the blade server cover" on page 64 for
5. Gently pivot the wide end of the card out of the expansion card connectors;
72
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
on page 59.
blade server from the BladeCenter unit. See "Removing and installing the blade
server in a BladeCenter unit" on page 61 for instructions.
instructions).
then, slide the notched end of the card out of the raised hook on the tray and lift
the card out of the blade server.
Expansion
card