Table of Contents
Advertisement
Setting up WPA-PSK Security
Follow the steps below to configure WPA-PSK Security.
1. Run the WPN111 Smart Wizard.
a. Make sure the WPN111 software is installed and the RangeMax WPN111 Wireless USB
2.0 Adapter is fully inserted in a USB port in your computer.
b. Use the
icon to open the Smart Wizard. The Settings tab page opens.
Figure 2-11
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
c. In the Security section, select WPA-PSK [TKIP].
For more about WPA, see the link to
3. Save your settings in a Profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply and then click Close to exit the Smart Wizard.
NETGEAR RangeMax Wireless USB 2.0 Adapter WPN111 User Manual
matches exactly what is configured in the access point.
v2.0, February 2007
"Wireless Communications:" in Appendix
B.
2-15
Advertisement
Table of Contents
