Table of Contents
Advertisement
Setting up WPA-PSK Security
Follow the steps below to configure WPA-PSK Security.
1. Run the WG311 v3 Smart Wizard.
a. Make sure the WG311 v3 software is installed and the WG311 v3 is properly installed in a
PCI slot in your computer.
b. Use the
icon to open the Smart Wizard. The Settings tab page opens.
Figure 2-11
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
c. In the Security section, select WPA-PSK [TKIP].
For more information, see the link to
3. Save your settings in a Profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Smart Wizard.
NETGEAR 54 Mbps Wireless PCI Adapter WG311 v3 User Manual
matches exactly what is configured in the access point.
v3.0, February 2007
"Wireless Communications:" in Appendix
B.
2-15
Advertisement
Table of Contents
