Troubleshooting; No Lights Are Lit On The Access Point - NETGEAR ME103 - 802.11b ProSafe Wireless Access Point User Manual

This chapter gives information about troubleshooting your ME103 802.11b ProSafe Wireless
Access Point. After each problem description, instructions are provided to help you diagnose and
solve the problem. For the common problems listed, go to the section indicated.
• Is the router on?
• Have I connected the wireless access point correctly?
Go to "Install the ME103 802.11b ProSafe Wireless Access Point" on page
• I can't remember the wireless access point's configuration password.
Go to "Changing the Administrator Password" on page
Note: For up-to-date ME103 installation details and troubleshooting guidance visit
www.netgear.com.
If you have trouble setting up your ME103, check the tips below.

No lights are lit on the access point.

It takes a few seconds for the power light to be lit. Wait a minute and check the power light
status on the access point.
The access point has no power.
• Make sure the power cord is connected to the access point.
• Make sure the power adapter is connected to a functioning power outlet. If it is in a power
strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it
is not a switched outlet.
• Make sure you are using the correct NETGEAR power adapter supplied with your access
point.

Troubleshooting

Troubleshooting
3-10.
Draft 2
Chapter 5
2-5.
5-1