User's Guide for the ME103 802.11b ProSafe Wireless Access Point
Default Factory Settings
When you first receive your ME103, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
Wireless Access Point Rear Panel" on page
User Name (case sensitive)
Password (case sensitive)
Access Point Name
IP Configuration
(if DHCP server is unavailable)
Network Name (SSID)
Radio Frequency Channel
Authentication Type
2-3
FEATURE
FACTORY DEFAULT SETTINGS
admin
password
netgearxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP
DHCP client
IP Address: 192.168.0.224
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Primary DNS Server: 0.0.0.0
Secondary DNS Server: 0.0.0.0
NETGEAR
802.11b
11
Open System
WEP
Disabled
802.1x
Disabled
1-7.
Basic Installation and Configuration
"ME103