Gigabyte GA-785GMT-USB3 User Manual page 26

6) IDE (IDE Connector)
The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attach-
ing the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices,
remember to set the jumpers and the cabling according to the role of the IDE devices (for example,
master or slave). (For information about configuring master/slave settings for the IDE devices, read the
instructions from the device manufacturers.)
7) SATA2_0/1/2/3/4 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The AMD SB710 controller supports RAID 0, RAID 1,
RAID 10, and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur-
ing a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 10 configuration requires at least four hard drives and the total number of hard drives
must be an even number.
Hardware Installation
SATA2_4
7
1
SATA2_3
SATA2_1
1
7
- 26 -
40 39
2 1
Pin No.
1
7
SATA2_2
SATA2_0
Please connect the L-shaped end of
the SATA 3Gb/s cable to your SATA
hard drive.
Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND