Motor Setup - DREAM MULTIMEDIA DREAMBOX DM 500S User Manual

19.

Motor Setup

Press the MENU-Button to enter the OSD-Mainmenu.
Go to Setup -> Service Searching -> Motor Setup.
Before proceeding with the Motor Setup refer to
passage Satellite Configuration and choose from
the upper Dropdownlist "many satellites via DiSEqC
Rotor" and press the OK-Button, if you setup a
Motor for the first time.
All possible satellites will be listed. Press the green
Option-Button to save this configuration.
After saving the Configuration, choose (3) Motor
Setup from the Menu Service Searching and press
the OK-Button. The Menu Motor Config appears.
Refer to the Rotors Manual for correct values
degrees/second. If unsure, set a check in front of
"Use Motor Input Power" and enter the maximum
current the Motor is using for turning to the Dish.
Visit the Website http://www.heavens-above.com
figure out your geographical location. Enter the
values for Longitude and Latitude and press the
green Option-Button to save.
Proceed to passage Automatic Multisat Scan.
- 19 -
to