Troubleshooting; The Machine Will Not Start; Overheating Cut-Off; Drying Takes Too Long - Asko DC7583 Operating Instructions Manual

Troubleshooting

The machine will not start

Check
• that the door is closed properly.
• that the main power switch is on.
• that the machine is not programmed to start at
a specific time (e.g., 13:30)
• that any plug is connected.
• that the fuses (circuit breakers) in your house
are intact. Flip the dryer breaker off and then
back on to make sure. You can not always tell
from the outside if the circuit breaker has
tripped.
• that the overheating cut-off has not been
triggered (see below).

Overheating cut-off

The overheating cut-out shuts off the drying
cabinet if the temperature is too high.
• The overheating cut-off will reset automatically
once the machine has cooled down.

Drying takes too long

• Poorly spun or very wet laundry.
• The drying cabinet is positioned in an area
where the ambient temperature is too low.
The garments do not dry, or are too
dry
• The door has been opened while the program
is running, which disrupts the moisture
monitoring function.
• The garments may not have been hung
correctly, obstructing the air flow. See
"Garment placement" in the "Operation"
chapter.
• Wrong program selected, choose another
program, see the "Operation" chapter.
• Poorly spun laundry or very wet laundry.
• The vent pipe/hose is too long. The length
should not exceed 39" (1 m).
• Normal operation requires installation in a room
with a temperature above 32 °F (0 °C).
24

Error messages

If F2 flashes on the display, the maximum
permitted program time has been reached. Read
"Drying takes too long" in the "Troubleshooting"
chapter to find out what to do.
Customer Care Center
1-800-898-1879
www.askousa.com