Table of Contents
Advertisement
Installation instructions
Installation
See the separate installation instructions
included in the set of documents.
Electrical installation
Connect the machine by plugging it into an
earthed wall socket. The electrical wall socket
must be placed outside of the installation area
to be easily accessible.
WARNING!
The receptacle on the rear of the machine is
designed to accommodate ASKO washers
ONLY (rated 208–240 V.) To use this receptacle,
you must use the ready-fi tted plug supplied with
the washing machine or an equivalent.
ASKO washers rated 208–240 V have two
internal fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
WARNING!
This appliance must be properly grounded.
Refer to the "Important Safety Instructions" for
grounding instructions.
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply
must be protected by a residual current device.
Connection to a permanently wired supply point
must be made only by a qualifi ed electrician.
As supplied: Single-phase, 230 V, 60 Hz,
3000W heater rating 30 A circuit required.
NOTE!
Do not connect the machine to the mains
electricity supply by an extension lead.
Customer Care Center
1-800-898-1879
www.askona.com
Remove cover to access teminal
box. (Requires- Torx screwdriver.)
23
Advertisement
Table of Contents
