Table
8‐1 lists and describes parameters for the single.sh utility.
Table 8-1. single.sh Parameters
Parameter
-A,--planArtifacts Attribute Artifacts
-a, -address address
-AddExU Additional UNIX Exclude
Directories
-AddExW Additional Windows Exclude
Directories
-AddIncU Additional UNIX Search Scope
-AddIncW Additional Windows Search Scope
-c, -Collector host
-d, -debug port
-D, -planCis Configuration Items
-e, -management Management IP
-ExU UNIX Exclude Directories
-ExW Windows Exclude Directories
-G, -planCiGroups CI Groups
-h, -help
-i, -interactive
-IncU UNIX Search Scope
-IncW Windows Search Scope
-j, -classpath classpath
-l, planhelp
-M, -maxdepth maxdepth
-n, -outputPrefix path
-p, -ports port
-P, -accessProfile Access profile
-r, -read filename
-t, -timeout timeout
VMware, Inc.
Description
Attribute artifacts to discover.
Address(es) of the discovery target. Use commas as separators.
Additional Exclude directories from search in the UNIX file
system.
Additional Exclude directories from search in the Windows file
system.
Additional Scope for search in the UNIX file system.
Additional Scope for search in the Windows file system.
Specifies the Collector that runs the actual discovery.
Start JVM with enabled remote debugging on the specified port
and wait for ENTER key before continuing.
Configuration items to discover.
Specifies the management IP to use if an access profile is read from
the management (using the -P option).
Exclude directories from search in UNIX file system.
Exclude directories from search in Windows file system.
Configuration Item groups to discover.
Brief help message.
Interactive mode that allows you to type protocol‐specific
commands.
Scope for search in UNIX file system.
Scope for search in Windows file system.
Adds additional path to the classpath. This additional path will
have the highest priority.
Prints information about available artifacts and artifact groups.
Maximum depth for search in file system.
Specifies the path prefix of the output file (for example, /tmp/).
Note: The directory path must end with a backslash (/). If this
option is not used, a predefined filename is used, and the file is
created in the current working directory.
One or more ports to use when connecting to the target host (for
scanning as well). Use commas as separators. These ports applies
even if the connection details are fetched from the management.
Discovery parameters or policy/access profile name to fetch from
the management.
Read from a playback or snmpdump file instead of going out to the
network.
Connect timeout to use when connecting to the target host. If
connection details are fetched from the management, they will
override this parameter.
Chapter 8 Troubleshooting ADM
51