Processor; Main Memory - Intel DP45SG - CARACTERISTIQUES TECHNIQUES Product Manual

Processor

CAUTION
Failure to use an appropriate power supply and/or not connecting the 12 V (2 x 2 pin)
power connector to the Desktop Board may result in damage to the board, or the
system may not function properly.
Intel Desktop Board DP45SG supports an Intel processor in the LGA775 package.
Processors are not included with the Desktop Board and must be purchased
separately. The processor connects to the Desktop Board through the LGA775 socket.
Go to the following locations for more information about:
• Instructions on installing or upgrading the processor, page 29 in Chapter 2
• Supported processors for Intel Desktop Board DP45SG,
http://processormatch.intel.com

Main Memory

NOTE
To be fully compliant with all applicable Intel
board should be populated with DIMMs that support the Serial Presence Detect (SPD)
data structure. If your memory modules do not support SPD, you will see a
notification to this effect on the screen at power up. The BIOS will attempt to
configure the memory controller for normal operation.
The Desktop Board supports the dual or single channel memory configurations defined
below:
• Four 240-pin Double Data Rate 3 (DDR3) SDRAM Dual Inline Memory Module
(DIMM) connectors with gold-plated contacts.
• 1333/1066/800 MHz DDR3 SDRAM interface
• Unbuffered, non-registered single- or double-sided DIMMs
• Non-ECC DDR3 memory
• Serial Presence Detect (SPD) memory only
• Up to 4 GB utilizing 512 Mb or 1 Gb technology
• Up to 8 GB utilizing 1 Gb or 2 Gb technology
NOTE
System resources and hardware (such as PCI and PCI Express) require physical
memory address locations that can reduce available addressable system memory.
This could result in a reduction of as much as 1 GB or more of physical addressable
memory being available to the operating system and applications, depending on the
system configuration and operating system.
Desktop Board Features
®
SDRAM memory specifications, the
13