Front Wheel & Brake System Troubleshooting; Front Wheels Removal; Front Wheels Installation - Eton VECTOR ST 250 Service Manual

14.2 TROUBLESHOOTING
HARD STEERING
FRONT WHEEL WOBBLING
BRAKE DRAG
STEERS TO ONE SIDE
POOR BRAKE PERFORMANCE
.3 FRONT WHEELS
14
REMOVAL
(The disassemble of front wheel system
in this serials are the same)
Raise the front wheels off the ground by placing a jack
or other support under the frame.
Remove the front wheel nuts, washer and wheels.
INSTALLATION
Install and tighten the four-wheel nuts
24 N.m (17.7 lbf.ft)
Torque:
Remember put a cotter pin in the castle nut.
Faulty tire
¡ ¹
¡ ¹ Insufficient tire pressure
¡ ¹ Faulty tire
¡ ¹ Worn front brake drum bearing
¡ ¹ Bent rim
¡ ¹ Axle nut not tightened properly
¡ ¹ Incorrect brake adjustment
¡ ¹ Sticking brake cable
¡ ¹ Bent tie rods
¡ ¹ Wheel installed incorrectly
¡ ¹ Unequal tire pressure
¡ ¹ Incorrect wheel alignment
¡ ¹ Brake shoes worn
¡ ¹ Worn brake drum
¡ ¹ Brake linings oily, greasy or dirty
¡ ¹ Improper brake adjustment
Wheel nuts
122