Table of Contents
Advertisement
206 STARTING AND OPERATING
• A 12 Volt heater built into the fuel filter housing aids in
preventing fuel gelling. It is controlled by a built-in
thermostat.
• A heated intake air system both improves engine
starting and reduces the amount of white smoke
generated by a warming engine.
Normal Starting Procedure – Engine Manifold Air
Temperature Above 66°F (19°C)
Observe the instrument panel cluster lights when starting
the engine.
1. Always apply the parking brake.
2. Shift into PARK for an automatic transmission. For
vehicles equipped with a manual transmission, fully
press and hold the clutch pedal and shift into NEUTRAL.
3. Turn the ignition switch to the ON position and watch
the instrument panel cluster lights.
CAUTION!
If the "Water in Fuel Indicator Light" remains on, DO
NOT START the engine before you drain the water
from the fuel filter to avoid engine damage. Refer to
"Maintaining Your Vehicle/Maintenance Procedures/
Draining Fuel/Water Separator Filter" in this manual.
4. Turn the ignition switch to START and crank the
engine. Do not press the accelerator during starting.
CAUTION!
Do not crank engine for more than 15 seconds at a
time or starter motor damage may result. Turn the
ignition switch to OFF and wait at least two minutes
for the starter to cool before repeating start proce-
dure.
5. When the engine starts, release the key fob.
Advertisement
Chapters
Table of Contents
