Table of Contents
Advertisement
3. If it isn't installed, install the power supply air baffle. All cables from the power supply should
route through the notch in the bottom of the baffle.
4. Connect the SCSI cable to the SCSI connector on the server board. Route the cable between
the memory connectors and the full height PCI riser, through the clips on the side of the
processor duct, through the notch in the top of the power supply air baffle, to the connector on
the backplane board.
✏
NOTE
It may be easier to route the SCSI cable after the full length PCI riser card is
installed.
5. Ensure that the front panel cable is connected to the front panel board, routed over USB cable
to the backplane, and connected to the matching connector.
Installing Peripherals
Peripherals and add-in cards are not included in your system and must be purchased separately.
The following sections describe how to install PCI add-in cards, hard disk drives, a DVD/CD-ROM
drive/floppy disk drive, and a tape drive.
34
B
Figure 21. Installing the Power Supply Air Baffle
A
OM14582
Intel SR2300 Chassis Subassembly Product Guide
Advertisement
Table of Contents
