Epson ActionPC 2000 Read This First Manual page 25

d. So you rebooted your system using
e. And the system did not load your sound card or
CD-ROM drivers.
If so, reset the computer by turning it off, waiting 20 seconds,
and turning it back on again. This should resynchronize the
sound card. If your computer still has trouble recognizing a
program after you run a memory-intensive one, do not
press
wait 20 seconds, and turn it back on again.
If your system locks up when it attempts to load your
sound card or CD-ROM drivers and will not completely
boot, your sound card or CD-ROM drive may be defective.
In order to continue using your system while you
investigate the problem, follow these steps:
1. Turn off the system.
2. Insert a bootable diskette and turn on your system
3. After it boots, log onto the root directory of your hard
disk.
4. Edit the AUTOEXEC.BAT and CONFIG.SYS files (as
described in step 1 on page 19) and add
to the beginning of any command lines that affect your
sound card and CD-ROM drive. (Or restore your
original system files as described in the next section.)
5. Remove the bootable diskette
6. Reboot your computer from the hard disk drive.
Contact your Authorized EPSON Customer Care Center or
the EPSON Connection to report the problem with your
sound card or CD-ROM drive; see page 6 for instructions.
22 Read This First
Ctrl Alt Del
to reboot it; instead, turn off your system,
Ctrl Alt Del
(remark)
REM