Epson 3000 Quick Setup Manual

PowerLite Home Cinema 3000/3500/3510/3600e
®

Quick Setup

Before using the projector, make sure you read the safety instructions in the
online User's Guide.
Note: These illustrations show the PowerLite Home Cinema 3600e, but the
instructions are the same for the PowerLite Home Cinema 3000/3500/3510
unless otherwise noted.
Connect the projector
Choose from the following connections. For additional connection types, see
the online User's Guide.
Note: To access the rear ports on the PowerLite Home Cinema 3600e, remove
the cable cover by using coins or your fingernails to lift up and out on the gaps
at the bottom of the cable cover.
Video device
Connect up to 4 video devices and use the Source buttons on the remote
control or the button on the projector to switch between them.
Mobile media device (PowerLite Home Cinema
3500/3510/3600e)
Connect tablets, smartphones, and other devices that support the MHL
standard to the HDMI 1/MHL port using a MHL compatible cable.
Note: Some devices may require an adapter or may not require an MHL
cable. Not all features or functions may be supported. Check your device's
documentation for more information.
WirelessHD (PowerLite Home Cinema 3600e)
Follow these steps to set up the included WirelessHD Transmitter.
1
Place the transmitter within 32 feet (10 m) of the projector. Make sure the
front of the transmitter faces the front of the projector. See the online
User's Guide for more information on the WirelessHD transmission range.
Note: Do not place the transmitter on a metal surface, as this may
interfere with the signal. Make sure there are no obstructions between
the transmitter and the projector.
2
Plug the AC adapter into the transmitter and a wall outlet.
HDMI cable
RCA video cable
Component video cable
™
MHL cable
3
Connect the HDMI cables to your video input devices and the HDMI ports
on the side and back of the WirelessHD Transmitter. You can connect up
to five input devices to the transmitter. See "Viewing WirelessHD content"
for information on switching between input sources
Note: You can connect tablets, smartphones and other devices that
support the MHL standard to the HDMI port on the side of the
WirelessHD Transmitter. Some devices may require an adapter or may not
require an MHL cable. Not all features or functions may be supported.
Check your device's documentation for more information.
4
To use the transmitter as a pass-through device to a television or other
display, connect an HDMI cable to the display device and the HDMI output
port on the rear of the transmitter. See "Viewing WirelessHD content" for
information on switching between wireless and wired display modes.
Connect audio
Built-in speaker (PowerLite Home Cinema
3500/3510/3600e)
The projector has a built-in speaker that can play audio from a connected video
source (DVD player, streaming device, etc.) using an HDMI connection. If you do
not use an HDMI connection, you can connect your device's audio output to the
projector's audio input.
Audio Out port (PowerLite Home Cinema
3500/3510/3600e)
You can connect the projector to external self-powered speakers through the
Audio Out port.
Note: You can also connect external self-powered speakers to the Optical Out
port on the WirelessHD Transmitter (PowerLite Home Cinema 3600e).
External speakers
Connect your device's audio output to your home theater receiver or powered
speakers.
Note: When outputting sound through an external source, you may need to
reduce the projector volume to zero or make sure that the correct audio output
is selected on your device to prevent duplicate sound from being heard from
the projector (PowerLite Home Cinema 3500/3510/3600e).
HDMI cable
Audio cable
3.5 mm stereo mini
cable