NETGEAR FVS318G - ProSafe Gigabit VPN Firewall Data Sheet Router Reference Manual page 58

ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
Table 4-2. Inbound Rules
Item Description
Service Select the desired Service or application to be covered by this rule. If the desired
service or application does not appear in the list, you must define it using the
Services menu (see
Action (Filter) Select the desired action for packets covered by this rule:
• BLOCK always
• BLOCK by schedule, otherwise Allow
• ALLOW always
• ALLOW by schedule, otherwise Block
Note: Any inbound traffic which is not allowed by rules you create will be blocked by
the Default rule.
Schedule Select the desired time schedule (Schedule1, Schedule2, or Schedule3) that will be
used by this rule (see
page
• This drop down menu gets activated only when "BLOCK by schedule, otherwise
• Use schedule page to configure the time schedules.
Send to LAN Server This field appears only with NAT Routing (not Classical). This LAN address
determines which computer on your network is hosting this service rule. (You can
also translate this address to a port number.)
Translate to Port Check this box and enter a port number to assign the LAN Server to a different
Number service port number. Inbound traffic to the service port will have the destination port
number modified to the port number configured here.
WAN Destination IP Specifies the destination IP address applicable to incoming traffic.
Address This is the public IP address that will map to the internal LAN server; it can either be
the address of the WAN port or another public IP address
LAN users This field appears only with Classical Routing (not NAT). Specifies which computers
on your network are affected by this rule. Select the desired options:
• Any – All PCs and devices on your LAN.
• Single address – Enter the required address and the rule will be applied to that
• Address range – If this option is selected, you must enter the start and finish fields.
• Groups – Select the Group to which this rule will apply. Use the LAN Groups screen
WAN Users Specifies which Internet locations are covered by the rule, based on their IP
addresses. Select the desired option:
• Any – All Internet IP address are covered by this rule.
• Single address – Enter the required address in the start field.
• Address range – If this option is selected, you must enter the start and end fields.
4-6
"Adding Customized Services" on page
"Setting a Schedule to Block or Allow Specific Traffic" on
4-29).
Allow" or "ALLOW by schedule, otherwise Block" is selected as Action.
particular PC.
(under Network Configuration) to assign PCs to Groups. See
and Hosts (LAN Groups)" on page
1.1 November, 2009
4-16).
.
3-5.
Firewall Protection and Content Filtering
"Managing Groups