NETGEAR FVS318G - ProSafe Gigabit VPN Firewall Data Sheet Router Reference Manual page 31

5. If you have installed login software such as WinPoET or Enternet, then your connection type
is PPPoE. If your ISP uses PPPoE as a login protocol:
Figure 2-8
a. Select Other (PPPoE).
b. Configure the following fields:
• Account Name. Valid account name for the PPPoE connection
• Domain Name. Name of your ISP's domain or your domain name if your ISP has
assigned one. In most cases, you may leave this field blank.
• Idle Timeout. Select Keep Connected, to keep the connection always on. To logout
after the connection is idle for a period of time, click Idle Time and in the timeout field
enter the number of minutes to wait before disconnecting.
6. If your ISP is Austria Telecom or any other ISP that uses PPTP as a login protocol:
a. Select Austria (PPTP).
b. Configure the following fields:
• Account Name (also known as Host Name or System Name). Enter the valid account
name for the PPTP connection (usually your email name as assigned by your ISP).
Some ISPs require entering your full email address here.
• Domain Name. Your domain name or workgroup name assigned by your ISP, or your
ISPs domain name. You may leave this field blank.
• Idle Timeout. Check the Keep Connected radio button to keep the connection always
on. To logout after the connection is idle for a period of time, click Idle Time and
enter the number of minutes to wait before disconnecting in the timeout field. This is
useful if your ISP charges you based on the amount of time you have logged in.
• My IP Address. IP address assigned by the ISP to make the connection with the ISP
server.
Connecting the FVS318G to the Internet
ProSafe Gigabit 8 Port VPN Firewall FVS318G Reference Manual
1.1 November, 2009
2-9