VPN Tunnel Configuration
There are two tunnel configurations and three ways to configure them:
•
Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
— See
"How to Set Up a Client-to-Gateway VPN Configuration" on page
— See
"How to Set Up a Gateway-to-Gateway VPN Configuration" on page
•
See
Chapter 6, "Advanced Virtual Private
defaults (see
Table 5-1
How to Set Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway (see
•
"Step 1: Configuring the Client-to-Gateway VPN Tunnel on the FVS318v3" on page 5-6
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
•
"Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 5-9
configures the NETGEAR ProSafe VPN Client endpoint.
FVS318v3
192.168.3.1
Figure 5-3: Client-to-gateway VPN tunnel
Basic Virtual Private Networking
Reference Manual for the ProSafe VPN Firewall FVS318v3
on
page
5-4) are not appropriate for your special circumstances.
Figure
5-3) involves the following two steps:
24.0.0.1
PCs
January 2005
Networking" when the VPN Wizard and its VPNC
VPN Tunnel
5-5.
5-20.
uses
PC
(Running NETGEAR
ProSafe VPN Client)
5-5