To Set At A Desired Speed; To Deactivate; To Resume Speed; To Vary The Speed Setting - Dodge 2004 DR Ram SRT-10 Owner's Manual

To Set At A Desired Speed

When the vehicle has reached the desired speed, press
and release the SET button. Release the accelerator and
the vehicle will operate at the selected speed.

To Deactivate

A soft tap on the brake pedal, normal braking, clutch
pressure while slowing the vehicle, or pressing the CAN-
CEL button will deactivate speed control without erasing
the memory. Pushing the ON/OFF button to the OFF
position or turning off the ignition erases the memory.
WARNING!
Leaving the Speed Control ON when not in use is
dangerous. You could accidentally set the system to
cause it to go faster than you want. You could lose
control and have an accident. Always leave the
system OFF when you aren't using it.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 97

To Resume Speed

To resume a previously set speed, push and release the
RESUME button. Resume can be used at any speed above
30 mph (50 km/h).

To Vary The Speed Setting

When the speed control is on, speed can be increased by
pressing and holding the ACCEL button. When the
button is released, a new set speed will be established.
Tapping the ACCEL button once will result in a speed
increase of 2 mph (3 km/h). Each time the button is
tapped, speed increases so that tapping the button three
times will increase speed by three increments.
Tapping the COAST button once will result in a speed
decrease of 1 mph (2 km/h). Each time the button is
tapped, speed will decrease. For example, tapping the
button 3 times will decrease the speed by 3 mph (6
km/h).
3