Reprogramming A Single Homelink Button; Security - Dodge 2004 DR Ram SRT-10 Owner's Manual

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. Do
NOT release the button.
2. The indicator light will begin to flash after 20 seconds.
Without releasing the HomeLink button, proceed with
Programming step 2
For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515.

Security

If you sell your vehicle, be sure to erase the frequencies.
To erase all of the previously trained frequencies, hold
down both outside buttons until the green light begins to
flash.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 111
This device complies with part 15 of FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may be
received including interference that may cause undes-
ired operation.
Changes or modifications not expressly ap-
NOTE:
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
HomeLink is a trademark owned by Johnson Controls,
Inc.
3